Step 3: mounting the prosine – Xantrex Technology PROsine 2.0 User Manual
Page 52
Installation
3–10
445-0089-01-01
Step 3: Mounting the PROsine
To mount the PROsine:
1. Remove the PROsine from its shipping container, verify that all components
are present, and record relevant product information on “Information About
Your System” on page WA–4.
2. Turn off the ON/OFF/REM switch on the AC end.
3. Select an appropriate mounting location and orientation.
(See Figure 3-2.)
To
meet regulatory requirements, the PROsine must be mounted in one of the
following orientations:
•
In a horizontal position on a vertical surface with the AC knockouts near
the top as shown in
Figure 3-2
•
On a horizontal surface
•
Under a horizontal surface
4. The PROsine Quick Installation Guide has a mounting template printed on it.
Tape it to the mounting surface and pilot-drill the desired number of mounting
holes. Remove the template.
5. Fasten the PROsine to the mounting surface. If you are mounting the unit on a
wall or bulkhead, use #12 or #14 pan-head wood or sheet metal screws to
secure it to the framing behind the wall or bulkhead. Alternatively, use nut
inserts and 1/4-20 machine screws.
Figure 3-2 Approved Mounting Orientations
Side near AC
knockouts
must be up.