Yamaha RX-Z11 - Manual (Page 115)

Saving and recalling the system settings (System Memory)
115
En
Ad
v
a
nce
d
Op
eratio
n
Use this feature to save and recall up to 10 of your favorite setting
for the main zone. You can also save up to four of your favorite
settings for Zone 2, Zone 3, or Zone 4.
■ Saving by the 7SYSTEM MEMORY buttons
You can save the current system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM MEMORY
buttons.
Press and hold one of the 7 SYSTEM MEMORY
buttons on the remote control for 4 seconds.
“MEMORY 1 SAVE” (example) appears in the front panel display,
and then this unit saves the current system setting to the
corresponding memory number.
• If system settings are already saved in the selected memory number, this
unit overwrites the old system settings.
• To save the system settings for Zone 2, Zone 3, or Zone 4, press HZONE
on the remote control repeatedly to select the operation zone setting of the
remote control and then press and hold the desired 7SYSTEM
MEMORY button for 4 seconds. You can save the system settings for the
selected Zone only when the zone is turned on.
• This unit saves the parameters in the groups you select by using the GUI
menu when you save the parameters by using the 7SYSTEM MEMORY
buttons.
■ Saving by the GUI menu operation
You can save the current system settings stored in “Memory1” to
“Memory10” by using the “System Memory” menu in the GUI
menu.
1
Press I
MENU on the remote control.
The top menu appears in the video monitor.
2
Press 9k / n repeatedly to select “System Memory”
and then press 9h.
The “System Memory” menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
4
Press 9k / n repeatedly to select “Main Save” and
then press 9h.
The following menu appears in the video monitor.
5
Press 9k / n repeatedly to select the desired
memory number (“Memory1” to “Memory10” or
“Memory4”) and then press 9h.
The list of the saved items appears in the video monitor.
Saving and recalling the system settings (System Memory)
Saving the current system settings
Before performing the following operations, set the operation mode
selector on the remote control to FAMP.
Notes
4 3
SYSTEM MEMORY
2 1
Stereo/Surround
Input Select
Manual Setup
Auto Setup
System Memory
Volume
Sound
Video
Main
Zone2
Zone3
Main Load
Main Save
Main Rename
Main Load
Main Save
Main Rename
Memory1
Memory2
Memory3
✓
✓
✓
✓
Memory1
Memory2
Memory3
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Save
Group of the system parameters
✓
✓
✓
✓
Memory1
Memory2
Memory3
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Save
Select: ENTER