Yamaha RX-Z11 - Manual (Page 76)

XM™ Satellite Radio tuning (U.S.A. and Canada models only)
76
En
■ Direct Number Access mode
1
Press I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or “CAT
SEARCH”.
2
Press the numeric buttons (B) on the remote control
to enter the desired three-digit channel number.
For example, to enter the number 123, press the numeric
buttons as shown below.
The display changes as follows.
y
• To enter a one-digit or two-digit channel number, press the numeric
buttons (B) on the remote control and then press NENT to confirm the
input number.
• If no button is pressed within a few seconds after you enter a one-digit or
two-digit number, this unit automatically confirms the entered channel
number.
• If you enter the number 0, this unit displays your XM Radio ID (see
page 74).
You can use this feature to store up to 40 XM Satellite Radio
channels (A1 to E8: 8 preset channel numbers in each of the 5
preset channel groups). You can then recall any preset channel
easily by selecting the preset channel group and number as
described in “Preset Search mode” on page 75.
1
Search for a channel you want to set as a preset
channel by using one of the XM Satellite Radio
search modes.
2
Press J
MEMORY (or 0MEMORY).
The MEMORY indicator flashes in the front panel display for
approximately 10 seconds.
You must proceed to and carry out steps 3 through 5 while the
MEMORY indicator is flashing in the front panel display.
3
Press M
PROGRAM (or 9CAT. l / h) repeatedly to
select a preset channel group (A to E) while the
MEMORY indicator is flashing.
The preset channel group letter appears in the front panel
display.
4
Rotate M
PROGRAM (or 9PRESET/CH k / n)
repeatedly to select a preset channel number (1 to 8)
while the MEMORY indicator is flashing.
The preset channel number appears in the front panel display.
A L L C H S E A R C H
C A T S E A R C H
or
CLASSICAL 1
1
CLASSICAL 2
2
LIVE/CLUB
3
< X M > - - 1
< X M > - 1 2
< X M > 1 2 3
Before performing the following operations, set the operation mode
selector on the remote control to FSOURCE and then press 3XM.
Setting the XM™ Satellite Radio preset
channels
Note
[ 0 4 3 ] X M U
Currently selected channel number
MEMORY
Flashes
MEMORY
C [ 0 4 3 ] X M U
Currently selected preset channel group Flashes
MEMORY
C 5 [ 0 4 3 ] X M U
Currently selected preset channel number Flashes