Yamaha RX-Z11 - Manual (Page 142)

Advanced setup
142
En
This unit has additional menus that are displayed in the front panel display. The advanced setup menu offers additional operations to adjust
and customize the way this unit operates. Change the initial settings (indicated in bold under each parameter) to reflect the needs of your
listening environment.
• The settings you make are reflected next time you press BMASTER ON/OFF inward to the ON position to turn on this unit (see page 43).
• Only BMASTER ON/OFF and MPROGRAM are effective while you are using the advanced setup menu.
• All the other operations cannot be made while you are using the advanced setup menu.
• The advanced setup menu is only available in the front panel display.
1
Press B
MASTER ON/OFF on the front panel to
release it outward to the OFF position to turn off this
unit.
2
Press and hold M
PROGRAM and then press
B MASTER ON/OFF inward to the ON position to
turn on this unit.
Press and hold
MPROGRAM until “ADVANCED SETUP”
appears in the front panel display.
3
Rotate the M
PROGRAM to select the parameter you
want to adjust.
The name of the selected parameter appears in the front panel
display.
4
Push M
PROGRAM repeatedly to change the
selected parameter setting.
5
Press B
MASTER ON/OFF to release it outward to
the OFF position to save the new setting and turn off
this unit.
y
The settings you made are reflected next time you turn on this unit.
■ Speaker impedance
SPEAKER IMP.
Use this feature to set the speaker impedance of this unit so that it
matches that of your speakers.
■ Remote sensor
REMOTE SENSOR
Use this feature to activate or deactivate the signal-receiving
capability of the remote control sensor on the front panel of this
unit.
We recommend setting the parameter to “ON” in most cases.
Advanced setup
Notes
Using the advanced setup menu
A D V A N C E D S E T U P
Choice Descriptions
8
ΩMIN
Select this setting to set the speaker impedance to 8 Ω.
The impedance of each speaker must be 8
Ω or higher.
6
ΩMIN
Select this setting to set the speaker impedance to 6
Ω.
The impedance of each speaker must be 6
Ω or higher.
Choice Descriptions
ON Select this setting if you want to activate the signal-
receiving capability of the remote control sensor.
OFF Select this setting if you want to deactivate the signal-
receiving capability of the remote control sensor.
Note