Yamaha RX-Z11 - Manual (Page 118)

Saving and recalling the system settings (System Memory)
118
En
■ Loading by the
7
SYSTEM MEMORY buttons
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM MEMORY
buttons.
y
To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE
on the remote control repeatedly to select the operation zone setting of the
remote control in advance. You can recall the system settings for the selected
zone only when the zone is turned on.
1
Press one of the 7
SYSTEM MEMORY buttons on
the remote control to select the desired memory
number.
“MEMORY 1 LOAD” (example) appears in the front panel
display.
y
“EMPTY” appears in the menu screen if no system settings are stored
in the selected memory number.
2
Press the selected 7
SYSTEM MEMORY button
once more to confirm the selection.
This unit loads the settings stored in the selected memory
number.
■ Loading by the GUI menu operation
1
Press I
MENU on the remote control.
The top menu appears in the video monitor.
2
Press 9k / n repeatedly to select “System Memory”
and then press 9h.
The “System Memory” menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
You can recall the system settings for the selected zone only when the
zone is turned on.
4
Press 9k / n to select “Main Load” and then press
9
h.
The following menu appears in the video monitor.
y
If system settings are already stored in the selected memory number,
the stored system parameter settings appear in the menu screen.
“Memory Empty” appears in the menu screen if no system settings are
stored in the selected memory number.
5
Press 9k / n repeatedly to select the desired
memory number where the system settings are
stored and then press 9h.
Once “Load: ENTER” appears in the video monitor, press
9ENTER to confirm the loading.
y
You can cancel the loading by pressing 9l.
6
Press I
MENU to exit from the GUI menu.
Loading the stored system settings
• Before performing the following operations, set the operation mode
selector on the remote control to FAMP.
• This unit overwrites the stored settings to the current settings of this
unit. If you do not want to erase the current settings, save the current
settings to any System Memory number in advance.
Note
Main Load
Main Save
Main Rename
Memory1
Memory2
Memory3
Memory1
Memory2
Memory3
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Memory1
Memory2
Memory3
Main Save
Input/HDMI Out
Audio
Volume
SP Config
Video
Option
Save
Load: ENTER