Xerox DocuColor 2045 - Manual (Page 26)

T O O L S M O D E
D O C U C O L O R 2 0 6 0 / 2 0 4 5 S Y S T E M A D M I N I S T R A T I O N G U I D E 1 – 4
Navigating in Tools Mode
The following table provides tells you how to navigate in Tools Mode by pressing
or touching keys or buttons.
NOTE: Changes made to features in the Tools Mode take effect when you exit
Tools Mode.
Machine Defaults and Feature Defaults
The Machine Defaults 1 screen appears when you first enter the Tools Mode.
You can change the default settings for the options shown on the Machine
Defaults 1, Machine Defaults 2, Feature Defaults 1, and Feature Defaults 2
screens. The Feature Defaults 2 screen is accessed by touching the More... tab.
The procedures used to change settings for the options shown on the screens are
described in detail after the figures below.
Key or Button Result
Tabs Allows you to view the options available on that screen.
Enter Saves any changes you made on the screen.
System Default Returns the settings on the screen to the factory default
settings.
Close Closes the screen and returns the system to the previous
screen.
Off Deactivates the feature.
Reset Returns the settings on the screen to the settings that
were in effect when the screen opened.
Cancel Cancels the changes made on the screen.
Exit Tools Exits the Tools Mode.