Xerox DocuColor 2045 - Manual (Page 92)

T O O L S M O D E
D O C U C O L O R 2 0 6 0 / 2 0 4 5 S Y S T E M A D M I N I S T R A T I O N G U I D E 1 – 7 0
Decurler Setup
Use the Decurler Setup feature to compensate for paper curl in your prints.
Paper curl is caused by many variables:
• The manufacturer’s brand of paper and the manufacturing lot.
• The weight of the paper, and if it is coated or uncoated.
• The amount of dry ink/toner and the area being covered on a sheet. The
heavier the coverage, the greater the tendency to curl.
• The atmospheric conditions of the room where the paper is stored.
• The atmospheric conditions of the room where the digital press with scanner
is located.
• The heat generated during the fusing processes.
The DocuColor 2060/2045 is equipped with an automatic curl control system that
uses the variables listed above to determine the amount of pressure needed at
different Decurlers to reduce the curl.
KEY POINT: If you notice that output prints have too much curl, first try
flipping over the stack of paper in the paper tray being used. You can also try
running the job from a different tray. If curl is still a problem, refer to the tables
below for your market area to change the default Decurler settings.
Decurler Specifications
The Decurler has both top and bottom adjustment arms that apply pressure to the
paper based on the selections made on the Decurler Setup screen. The degree of
pressure is applied independently to the top and bottom Decurler arms.