Xerox DocuColor 2045 - Manual (Page 95)

T O O L S M O D E
D O C U C O L O R 2 0 6 0 / 2 0 4 5 S Y S T E M A D M I N I S T R A T I O N G U I D E
T
O
OL
S
M
OD
E
1–73
3
When a Paper Tray on the screen is selected, the default selections for Paper
Weight and Paper Type are automatically selected. Touch the number of the
Paper Tray from which the paper is feeding.
The button for Paper Tray 4 displays only if this optional tray is connected. The
button for 221 - 280 g/m
2
displays only for Tray 3.
4
If there is still too much paper curl after trying the tips in the Key Point on the
previous page, follow the remaining steps in this procedure.
KEY POINT: Paper Tray 3 accepts paper weights from 64 to 280 g/m
2
. If you
select Paper Tray 3 or 4, buttons for Uncoated and Coated are displayed under
the Coating heading.
NOTE: Your configuration may not show Tray 4.
If the optional Paper Tray 4 is connected, a button for Tray 4 is displayed under
Paper Trays. You may select from any of the displayed paper weights; 64 to 220
g/m
2
, and either coated or uncoated paper. Select the correct paper type if other
than Paper Type A. Refer to the tables shown previously in this section for the
default settings for various market areas.
5
Touch the Close button to save your selections and return to the Machine
Defaults 2 screen. Exit the Tools Mode and run a few test prints to determine if
the curl was reduced to a satisfactory level.
If curl is still excessive, access the Tools Mode again and try another Paper Type
setting. If you are not successful in reducing the curl, call your Xerox service
representative.
6
Touch the Reset button on the Decurler Setup screen to return to the settings
established when you first accessed the screen.