Zenith DTV1080 - Manual (Page 35)

4. ZENITH HD SATELLITE RECEIVER OPERATION
34
4-2. Using the Remote Control
Power
Turns the HD satellite receiver on and off. If your remote control is
programmed to control other components such as VCR, DVD, etc.,
Power will turn the component on and off. If you want to control
other components from different manufacturers, you must first pro-
gram your remote control. For further instructions on remote control
programming, please refer to the section 4.3 of this operating guide
or the Program Remote section of on-screen help.
Mode
Selects the component that will be controlled by the remote. For
example, if your remote control is set to VCR, the CH +/- button will
change the channel number of the VCR. If you want to control other
components from different manufacturers, you must first program
your remote control.
Digit Buttons (0~9)
Allows you to enter channel numbers for direct tuning or to scroll to
the designated page of the program list on the Guide menu. Digit
buttons can be used to enter numerical values wherever required
e,g, to enter a password.
Dash (-)
Is used to enter a channel number for multiple program channels
such as 2-1, 2-2, etc. A broadcaster may transmit multiple programs
on a single channel. Multiple programs are distinguished by a
unique sub-channel number, separated by a dash (-).
Enter ( )
Use with numbered buttons for instant channel selection. When you
press a channel number, for example, 22, the receiver awaits anoth-
er stroke for three seconds and then tunes to 22.
1 2 3
4 5 6
7 8 9
0
POWER
DIRECTV VCR AUX
TV DVD
MUTE
ENTER
SIGNAL FREEZE FLASHBK CC/DATE
MENU
HELP
RECORD STOP L CHAP R CHAP
PAUSE REW PLAY FF
EXIT
GUIDE SURF
INFO
VOL
CH
Pg Up
Pg Dn
RATIO
MODE
1
2
3
4
5
1
2
3
4 5
206-3675