Static route screens, 1 static route overview, 2 ip static route screen – ZyXEL Communications NBG334SH User Manual
Page 133: Chapter 13 static route screens, Figure 74 example of static routing topology, Static route screens (133)
ZyXEL NBG-334SH User’s Guide
133
C
H A P T E R
13
Static Route Screens
This chapter shows you how to configure static routes for your ZyXEL Device.
13.1 Static Route Overview
Each remote node specifies only the network to which the gateway is directly connected, and
the ZyXEL Device has no knowledge of the networks beyond. For instance, the ZyXEL
Device knows about network N2 in the following figure through remote node router R1.
However, the ZyXEL Device is unable to route a packet to network N3 because it doesn't
know that there is a route through the same remote node router R1 (via gateway router R2).
The static routes are for you to tell the ZyXEL Device about the networks beyond the remote
nodes.
Figure 74 Example of Static Routing Topology
13.2 IP Static Route Screen
Click Management > Static Route to open the IP Static Route screen. The following screen
displays.