ZyXEL Communications NBG334SH - Manual (Page 145)

Chapter 14 Bandwidth Management
ZyXEL NBG-334SH User’s Guide
145
Figure 80 Bandwidth Management Rule Configuration: Pre-defined Service
The following table describes the labels in this screen.
14.9.2 Rule Configuration with the User-defined Service
In addition to the pre-defined services, if you want to edit a bandwidth management rule for
other applications and/or subnets, click the Edit icon in the User-defined Service table of the
Advanced screen. The following screen displays.
Table 59 Bandwidth Management Rule Configuration: Pre-defined Service
LABEL DESCRIPTION
# This is the number of an individual bandwidth management rule.
Enable Select an interface’s check box to enable bandwidth management on that
interface.
Direction These read-only labels represent the physical interfaces. Bandwidth
management applies to all traffic flowing out of the router through the interface,
regardless of the traffic’s source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the
ZyXEL Device and be managed by bandwidth management.
Bandwidth Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
Destination Port This is the port number of the destination. See Table 55 on page 140 for some
common services and port numbers.
Source Port This is the port number of the source. See Table 55 on page 140 for some
common services and port numbers.
Protocol This is the protocol (TCP or UDP) used for the service.
OK Click OK to save your customized settings.
Cancel Click Cancel to exit this screen without saving.