Yamaha 006IPTO-F0 - Manual (Page 104)

104
Chapter 8—Aux Sends
DM1000 Version 2—Owner’s Manual
Panning Aux Sends
You can pair adjacent odd-even (in this order) Aux Sends for stereo operation. This enables
you to pan signals from Input Channels to paired Aux Sends.
1 Pair the desired two Aux Sends. (See page 89 for more information on pair-
ing channels.)
2 Use the AUX SELECT [AUX 1]–[AUX 8] buttons to select one of the paired
Aux Sends.
3 Press the AUX SELECT [DISPLAY] button repeatedly until the page listed
below that contains the desired channels appears.
- Pan1–32 page
This page enables you to pan signals routed from Input Channels 1–32 to Aux Sends.
- Pan33–48 page
This page enables you to pan signals routed from Input Channels 33–48 to Aux Sends.
The parameters on these two pages (and the procedure for setting them) are the same.
A Aux pan controls
These controls adjust the pan setting of signals routed from Input Channels to paired
Aux buses.
B MODE
The MODE parameter determines how paired Input Channels are panned.
C INPUT PAN LINK
When this parameter is turned on, Aux Sends follow the Input Channel Pan.
4 Move the cursor to the Aux pan control of the desired Input Channel and
rotate the Parameter wheel to set the pan value.
5 If necessary, move the cursor to the MODE parameter box and rotate the
Parameter wheel to select INDIVIDUAL, GANG, or INV GANG, then press
[ENTER].
If the INPUT PAN LINK ON/OFF button is turned off, this Mode setting is independent of
the Mode parameter on the Pan page. (See page 70 for more information on Mode
options.)
3 2
1