Yamaha 006IPTO-F0 - Manual (Page 278)

278
Chapter 20—Other Functions
DM1000 Version 2—Owner’s Manual
At this time, the trigger signal is output from the CONTROL port when you operate the
assigned parameters or controls.
■ Parameters available in the INPUT section
• TALKBACK/DIMMER .......................Same as the MONITOR [TALKBACK] and
[DIMMER] button functions.
• BUS/SLOT ............................................Same as the MONITOR [BUS] and [SLOT] but-
ton functions.
• STEREO/2TRD1/2TRD2....................Same as the MONITOR [STEREO], [2TRD1],
and [2TRD2] button functions.
Tip: Refer to the next page for a complete list of assignable parameters and controls.
No Assign AUX1 ON
TALKBACK :
DIMMER AUX8 ON
BUS ST ON
SLOT CH1 ON UNLATCH
STEREO :
2TRD1 CH48 ON UNLATCH
2TRD2 BUS1 ON UNLATCH
TALKBACK UNLATCH :
DIMMER UNLATCH BUS8 ON UNLATCH
BUS UNLATCH AUX1 ON UNLATCH
SLOT UNLATCH :
STEREO UNLATCH AUX8 ON UNLATCH
2TRD1 UNLATCH ST ON UNLATCH
2TRD2 UNLATCH UDEF1
CH1 ON :
: UDEF12
CH48 ON
BUS1 ON
:
BUS8 ON
Trigger signal polarity =
Output signals from
the CONTROL port
Trigger signal polarity =
Output signals from
the CONTROL port