Yamaha 006IPTO-F0 - Manual (Page 105)

Excluding Certain Channels from Aux Sends (Mix Minus)
105
DM1000 Version 2—Owner’s Manual
8
Aux Sends
6 To link the Input Channel Pan setting with the Aux Send Pan setting, move
the cursor to the INPUT PAN LINK ON/OFF button, then press [ENTER].
The pan positions on the Pan page are copied to the Aux pan setting, and the pan controls
on both pages are linked.
Excluding Certain Channels from Aux Sends (Mix Minus)
You can quickly exclude signals from certain channels from Aux Sends by using the controls
on the top panel. This operation is called “Mix Minus.”
For example, when Aux Sends are being used as monitors for the musicians or a narrator,
you can turn off the audio signals of the musicians or narrator, excluding them from the
monitor sound.
1 Press and hold down the AUX SELECT [AUX 1]–[AUX 8] buttons of the desired
Aux Sends.
The [ON] button indicators in the channel strip section remain lit while you hold down the
button. This means that signals routed from channels with a lit [ON] button indicator to
the Aux Send are turned on.
2 Press the [ON] buttons of the Input Channels you wish to exclude from the
Aux Send. You can select multiple channels.
The selected channels’ [ON] button indicators turn off, and signals routed from those
channels to the corresponding Aux Send are turned off. “MIX MINUS FOR AUX * ”
appears on the bottom of the screen. (The asterisk represents an Aux number.)
3 To reset the setting, while pressing and holding down the [AUX 1]–[AUX 8]
buttons you pressed in Step 1, press the [ON] buttons you pressed in Step 2.
The corresponding [ON] button indicators light up.
Tip:
• If paired Aux Sends are in Variable mode, the Aux Send levels, Aux On/Off, and Pre/Post
parameters for paired Input Channels are linked to each other.
• If paired Aux Sends are in Fixed mode, the Aux On/Off parameters for paired Input Chan-
nels are not linked to each other.
Note: If you release the button in the AUX SELECT section before you proceed to Step 2, you
will be unable to complete the Mix Minus operation.
Tip: At this time, the Send Level controls on the Aux | Send page are grayed out.