Yamaha 006IPTO-F0 - Manual (Page 36)

36
Chapter 3—Operating Basics
DM1000 Version 2—Owner’s Manual
Selecting Encoder Modes
The function of Encoders (1–16) depends on the selected Layer and Encoder mode.
1 Select a layer that includes the desired channel (see page 33).
2 Press the corresponding ENCODER MODE button to
select an Encoder mode.
• When the [PAN] button indicator
lights up: ...............................................Encoders 1–16 function as
Pan controls for the
selected layer.
• When the [AUX] button indicator
lights up: ...............................................Encoders 1–16 function as Aux Send level con-
trols for the selected layer.
• When the [ASSIGN] button indicator
lights up: ...............................................Encoders control the parameters assigned to the
[ASSIGN] button for the selected layer. (See the
next section for more information on how to
assign parameters to the [ASSIGN] button.)
The following table shows the Encoder functions for each Layer and Encoder mode.
LAYER buttons Encoder Mode
Channel Strip Encoder
1–8 9–16
[1-16] button
Pan Input Channels 1–16 pan
Aux Input Channels 1–16 Aux Send level
Assign Assigned parameter 1
1. If ALT LAYER is assigned, the Encoder controls the parameters assigned to the faders of the layer that
is currently not selected (if Layer 1-16 is currently selected, the Encoder controls the parameters as-
signed to the faders in Layer 17-32; if Layer 17-32 is currently selected, the Encoder controls the pa-
rameters assigned to the faders in Layer 1-16).
[17-32] button
Pan Input Channels 17–32 pan
Aux Input Channels 17–32 Aux Send level
Assign Assigned parameter 1
[33-48] button
Pan Input Channels 33–48 pan
Aux Input Channels 33–48 Aux Send level
Assign Assigned parameter
[REMOTE 1] button
Pan
Operation depends on the selected target (see
page 215).
Aux
Assign
[REMOTE 2] button
Pan
Aux
Assign
[MASTER] button
Pan
No operation
Aux
Assign Assigned parameter
AUX PAN
DISPLAY
ASSIGN
ENCODER MODE