Zoom 5651A - Manual (Page 11)

Chapter 1: Installation Instructions 11
DSL light should blink once. If the POWER light does not
turn on, make sure there is power at the wall outlet or power
strip where you plugged in the power cube.
4
Turn the computer on.
If you are using the USB port, you may see a Found New
Hardware box indicating the progress of the installation.
Typically no user action is necessary.
If you are using Windows XP, you may be required to click
Next.
Depending on your operating system, you may also see a
Hardware Installation box or a Digital Signature Not
Found box. You can safely ignore these messages and click
Yes or Continue Anyway.
If prompted, click Finish and/or Yes to restart your computer
at this point and then finish setting up your new hardware.
5
Plug one end of the supplied phone cord into the modem’s
DSL port and the other into the ADSL wall jack. The DSL
light should blink and then become steady on. If it does not,
refer to the Troubleshooting section on page 53.
Note: We recommend that at this point, if you haven’t
already done so, you put an ADSL filter on every phone
connected to the ADSL phone line. DO NOT put a filter
between the X4 and the wall jack that it is connected to.
(In some countries, including the UK, a splitter is supplied
with the X4. The PHONE line plug of the splitter plugs
into the wall jack that has ADSL service, and the X4 plugs
into the splitter's MODEM jack, which is not filtered. The
PHONE jack, for an optional telephone, is filtered.)
Congratulations! You have installed the hardware. Now
continue below with Establishing Communication.