Zoom 5651A - Manual (Page 19)

Using Static IP Addressing
If your Internet service provider’s Encapsulation setting is either
1483 Bridged or 1483 Routed, the X4 can be set for either a
Dynamic Host Configuration Protocol (DHCP) address (also
known as a dynamic IP address) or for a static IP address.
Because most Internet service providers use DHCP, the X4 is
set for dynamic IP addressing by default.
There is typically an extra charge for a static IP address, and you
usually have to make a special request to get one.
Important!
If you do not know what static IP addressing is or why you would
use it, you most likely do not need to change the default setting.
Only advanced users who specifically want to use static IP
addressing and/or those users whose IP provider specifically
instructed them to use static IP addressing should change this
setting.
1
Click the Advanced Setup icon at the top of any page in
the Zoom Configuration Manager to open the Advanced
Setup page.
2
Click the WAN Configuration button, located in the
Configuration group.
Chapter 1: Installation Instructions 19