Zoom 5651A - Manual (Page 14)

¾ Select AUTOMATICALLY if neither of the special
circumstances mentioned above fits your situation. When
this option is selected, the screen changes to show
automatic configuration options. Do the following:
a
Select the Enable option button, then click Save
Changes.
b
The page changes to the Autodetect page and a Start
button appears. Click the Start button to begin the
automatic configuration. A message appears to let you
know that the current configuration, if any, will be lost
when the X4 configures itself. Click OK to dismiss
this message.
c
Wait while the X4 modem searches for the correct
VPI, VCI, and Encapsulation settings and connects
with your Internet service provider. This may take a
few minutes because the modem must try various
combinations until it finds the settings that match your
service provider’s.
3
Once the modem detects your settings, your VPI, VCI, and
Encapsulation settings will appear in the table on the
Autodetect page. Click the Encapsulation setting to continue
with the process.
14 ADSL X4 User Guide
Note:
If your Encapsulation setting is not found (that is, if “No
Encapsulation Protocol Detected” remains on the screen),
select the Disable option button, click Save Changes, then
click the Basic Setup icon at the top of the screen and try to
manually configure the modem, as explained in Configuring
the X4 Manually on page 16.
When your Encapsulation
setting appears, click it to
continue with the process.
(Note that yours may be
something other than
PPPoE.)