Zoom 5651A - Manual (Page 12)

12 ADSL X4 User Guide
Important!
You must ensure that your computer’s TCP/IP settings are
configured properly. See Macintosh TCP/IP Settings on page 47
or Linux TCP/IP Settings on page 49 for instructions on how to
do this.
Establishing Communication
You must set up the X4 so that it can communicate with your
Internet service provider. To do this, you use the Zoom
Configuration Manager.
1
Follow these two steps to log in to the Zoom Configuration
Manager:
a
Open your Web browser and, in its address bar, type
http://10.0.0.2 if you are using the Ethernet jack or
http://10.0.0.3 if you are using the USB port (Windows
only), then press the Enter key on your keyboard.
b
When prompted, type the following user name and
password in the appropriate boxes, then click OK. You
must enter them using lowercase letters.
User Name: admin
Password: zoomadsl
If you are not prompted for a user name and password, do
the following in this order: Recheck all connections; restart
the modem and computer; and reset the modem by
inserting a paper clip into the Reset pinhole in the center
of the modem’s back panel and holding it for five seconds.
The user name and password you enter here do not serve
the same purpose as any name and password that your
Internet service provider may have given you.