Zoom 5651A - Manual (Page 39)

39
Restoring Default Settings
If you have changed the system settings on your X4 and for some
reason want to restore them to the factory default settings, you can
do so in one of two ways: You can perform a software reset or a
hard reset.
To reset using the X4’s Web interface
If you can open your Web browser and access your X4’s user
interface, do the following to perform a software reset:
1
Log into the Zoom Configuration Manager and click the
Advanced Setup icon to open the Advanced Setup page.
(See page 12 if you need help logging in.)
2
In the Administration section, click the Reboot button.
3
From the Reboot Mode drop-down list, select Reboot From
Default Configuration.
4
Click the Reboot button. Once this process is complete, your
unit is reset to its factory settings.
To perform a hard reset
If you lose your link to the unit and cannot communicate with it
via the Web browser, do the following to perform a hard reset:
1
Insert a paper clip into the RESET pinhole in the center of
the modem’s back panel.
2
Hold it there for five seconds. The unit’s DSL light will turn
off and then it will blink slowly, about once per second.
You are now guaranteed that all system settings are restored to the
X4’s factory defaults.