3Com Network Video Server FlexWATCH 3110 - Manual (Page 54)

Network Video Server User’s Manual
Seyeon Tech Co., Ltd 54
Once PPPoE is enabled, LAN network setting will be disabled.
3 Network port configuration
HTTP port, NVCP and VDCP ports are application port through which video and audio data
can be transmitted over the TCP/IP network.
3.1 HTTP port configuration
When you need to change Default HTTP Port (#80) to other port, you can change
HTTP port. This is very useful when more than one server should be installed behind a
router.
By assigning different HTTP port number for each server and configure port-forwarding
feature of Router, you can install more than one server behind the router.
For more information about this, please contact your local vendor.
3.2 NVCP –Tx Port
Tx port is a TCP port number through which FlexWATCH TM server can communicate with
other devices such as FW-5440 or FW-5000 NDVR servers. This port number is user
definable.
NVCP-Tx port must be opened when the FlexWATCH
TM server transmits data through
Internet in a Passive way (When TX Module Registration is configured as PASSIVE
MODE). When NVCP port is to be used, you must open TCP port in the router as well.
3.3 VDCP Port configuration
VDCP port is UDP port for Voice Communication. By changing VDCP port (Default number
is 32001), you can install more than one Voice kit and Video server under the
router.
- INTPLUS [2005] -