Edimax Technology EW-7428HCn - Manual (Page 29)

29
Band Please select the wireless band you wish to
use. By selecting different band settings,
you’ll be able to allow or deny wireless
clients using certain bands.
If you select 2.4GHz (B), 2.4GHz (N), or
2.4GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11n,
or 802.11g) will be able to connect to this
access point.
If you select 2.4GHz (B+G), then only
wireless clients using the 802.11b and
802.11g bands will be able to connect to
this access point.
If you want to allow 802.11b, 802.11g, and
802.11n clients to connect to this access
point, select 2.4GHz (B+G+N).
MAIN ESSID Please input the ESSID (the name used to
identify this wireless access point) here. You
can input up to 32 alphanumerical
characters. Please note that the ESSID is
case sensitive.
Multiple ESSID When you press this button, a new window
will appear, allowing you to assign up to
four ESSIDs to this access point. Please see
the following page for more details.
AP Isolation When this is set to “Enabled”, wireless
clients connected to this device will be able
to access the Internet, but will not be able
to communicate with each other. This
applies to clients connected to the MAIN
ESSID only.
SSID Isolation When the access point uses multiple SSIDs
and this is set to “Enabled”, then wireless
clients connected to the same SSID will be
able to communicate with each other, but
will not be able to communicate with other
wireless clients connected to another of this