Edimax Technology EW-7428HCn - Manual (Page 71)

71
password and click “Ok”. See below for
more information.
Note: Restoring settings to the factory default will
restore all settings, configurations and passwords
back to the factory default.
Note: You can also reset the device to the factory
default by pressing and holding the Reset/WPS
button for 10 seconds, until the Power LED (
)
goes out. The Reset/WPS button is located on the
front panel of the device.
Restore to factory defaults
When you restore to factory defaults, the Power LED (
) on the device will
go out. The access point will then begin its initialization process. The Wi-Fi LED
(
) will flash rapidly, until the Power LED ( ) lights back up. When the
Power LED ( ) lights up and stays on steadily, the device has successfully
reinitialized and is ready for further configuration.
Note: Take care to hold down the Reset/WPS
button for at least 10 seconds. Releasing the button
too early will cause the device to enter WPS
connection mode.
In the sidebar, there are 3 further tools within the “Configuration Tools” menu.