FIAT Ulysse User Manual
Page 159
IN AN EMERGENCY
158
15) Warn other passengers that the
vehicle is about to be raised; all per-
sons should be kept away from the ve-
hicle until it has been lowered.
16) Turn the jack handle and raise
the vehicle until the wheel is a few
inches off the ground. Make sure the
jack handle can be turned easily and
take care not to scrape your hand
against the ground.
17) The moving parts of the jack
(screw and joints) may also cause in-
jury if touched. Clean off any grease.
18) Loosen the five bolts complete-
ly and remove the wheel.
19) When fitting the spare wheel,
make sure the hub is clean so that the
bolts will not loosen.
20) Fit the spare wheel making one
of the holes A-fig. 9 coincide with pin
B. Now tighten the five wheel bolts
with the handle .
21) Lower the vehicle by turning the
handle and remove the jack.
22) Fasten bolts completely, work-
ing in a criss-cross fashion as shown in
fig. 10.
23) Refit the wheel cap (where fit-
ted) and make groove A-fig. 11 match
with the wheel inflation valve.
fig. 8
F0B0123b
fig. 9
F0B0124b
fig. 10
F0B0125b