FIAT Ulysse - Manual (Page 90)

GETTING TO KNOW YOUR CAR
89
Memorisation of a speed: (only in
4 th or 5 th gear and at speeds above
40 km/h): Move lever A to ON, the
current speed of the vehicle is main-
tained and memorised and wording
“ON” under the speedometer symbol
will turn on, on the odometer display.
If necessary, the speed set may be in-
creased by pressing the accelerator
pedal (e.g. when overtaking); when the
pedal is released the system will return
the speed of the vehicle to that mem-
orised previously.
Acceleration or deceleration
(using lever only): when the vehicle
is travelling at an automatic regulated
speed, move the lever B to deceler-
ate or C to accelerate.
Disengagement of the device:
press button D on the lever edge.
The device will switch itself off au-
tomatically when the brake or clutch
pedal is pressed.
Restoring the memorised speed:
after pressing the brake or clutch ped-
al or after the device has been disen-
gaged, press button D to restore the
last speed memorised.
Memory deletion: turn button
from ON to OFF to clear all the mem-
ories.
IMPORTANT Use the speed con-
trol system only when the traffic or
road conditions make it possible to
maintain a constant speed.
MANUAL GEARBOX
To engage the gears, press down the
clutch and put the gear lever into one
of the positions shown in the diagram
on the gear lever knob.
IMPORTANT To put the vehicle
in reverse, the vehicle must be sta-
tionary. Then with the engine running,
shift into reverse and wait at least
2 seconds with the clutch pedal
pressed fully to avoid scraping and
damaging the gears and back.
fig. 109
F0B0073b