FIAT Ulysse - Manual (Page 33)

GETTING TO KNOW YOUR CAR
32
Make sure the anchor-
age holes are always
clean; if debris has got in-
to them it interferes with the
seats being locked securely into
place.
Before starting off again,
make sure that the seats
are facing the front of the
vehicle and are properly fastened
to their anchorage points. The
seat belts can only be used effec-
tively in this position.
The seats can be arranged in other
ways by removing the middle row and
thus increasing the space available be-
tween the first and third row.
fig. 47
F0B0025b
fig. 45
F0B0032b
fig. 46
F0B0033b
HEAD RESTRAINTS
Remember the head re-
straints must be posi-
tioned so that they sup-
port the back of the head and not
the neck. Only in this position will
they protect you properly in the
event of an end-shunt collision.
Front seats fig. 47
The head restraints can be adjusted
for height and tilt.
To adjust height, lift or lower the
head restraint to get the required po-
sition.
To make the adjustment operate the
head restraint as shown in the figure.
In order to use the head
restraint in the correct
way, adjust the seat back
so that the chest is in upright po-
sition and the head is as closest to
the head restraint as possible.