FIAT Ulysse - Manual (Page 16)

GETTING TO KNOW YOUR CAR
15
DUPLICATE KEYS
Go directly to your Fiat Dealer-
ship, taking all the keys in your pos-
session and the CODE card with you.
The codes of any keys that are not
available when the new storage pro-
cedure is carried out will be deleted
from the memory to prevent any lost
or stolen keys being used to start the
engine.
All the keys and the CODE card
must be handed over to the new own-
er when selling the car.
OPERATION
When the ignition switch is turned
to S the Fiat CODE system deacti-
vates the engine control unit functions.
After the engine is started by turning
the key to M, the Fiat CODE system
control unit sends the code for the
function lock deactivation to the en-
gine control unit. The crypted and
varying code is sent only if the system
control unit has recognised the code
sent by the electronic device con-
tained in each ignition key, through the
signal emitted by a special aerial built
into the ignition switch.
If the code is not recognised, you are
recommended to turn the key to S
and then again to M; if the lock cannot
be deactivated, repeat the operation
with the other key provided with the
vehicle.
If you are still not able to start the
engine contact a Fiat Dealership.
IMPORTANT Each key supplied
with the vehicle has its own code
which is different from all the others
and which must be stored in the mem-
ory of the system control unit. Con-
tact a Fiat Dealership for the new
key storage procedure, taking with
you the CODE card, a personal iden-
tity document and the vehicle owner-
ship documents.
The codes of any keys
that are not available
when the new storage
procedure is carried out will be
deleted from the memory when
all the keys are stored again, in
order to prevent any mislaid keys
being used to start the vehicle.