FIAT Ulysse - Manual (Page 56)

GETTING TO KNOW YOUR CAR
55
IMPORTANT Any anomalies
should be reported to your Fiat
Dealership immediately without
waiting for the next servicing coupon
to be carried out.
A - Maintenance warning lamp.
B - Kilometre counter.
C - Configuration and reset button.
O PERATION
When the key is turned to M, warn-
ing lamp A will light up for some sec-
onds and the kilometre counter B will
display the number of kilometres
(rounded down) still to be travelled
before the next servicing is due. Af-
ter this period the engine oil level
(where fitted) will be automatically dis-
played and then the total kilometres
travelled will be displayed as well;
– maintenance due after 2000
km until the maintenance dead-
line: when the key is turned to M,
warning lamp A will light up and the
kilometre counter B will display the
number of kilometres (rounded
down) still to be travelled before the
next servicing is due. After some sec-
onds the warning lamp will remain lit
and the total travelled kilometres will
be displayed;
– maintenance overdue: when
the key is turned to M, warning lamp
A will flash for some seconds and the
number of kilometres over the main-
tenance limit will be displayed; after
this period the warning lamp will re-
main lit and the total travelled kilo-
metres will be displayed.
IMPORTANT If, after about
12 months, the kilometres indicated in
the Service Schedule have not been
reached yet, when the key is turned to
M, warning lamp A will light up and
the kilometre counter will show 0 km.
In this case contact a Fiat Dealer-
ship.
C ONFIGURATION PROCEDURE
If the vehicle is used in particularly
difficult conditions, you are recom-
mended to reset the system and re-
duce the maintenance frequency from
30,000 to 20,000 km.
To alter the maintenance frequency:
– turn the key to M;
– press button C and keep it
pressed, so the number of kilometres
still remaining or already passed since
the scheduled servicing will flash;
– release the button immediately to
display the preset maintenance fre-
quency;
– a repeated press on button C will
change the maintenance frequency to
the one required:
30,000 km (recommended in nor-
mal use conditions);
20,000 km (recommended in se-
vere use conditions);
– when the selected maintenance fre-
quency is displayed, press button C for
10 seconds (the maintenance fre-
quency selected will flash for 10 sec-
onds);
– release the button to confirm as
soon as the display stops flashing.