Garmin G950 Tecnam 2006T - Manual (Page 93)

190-01146-00 Rev. A Garmin G950 Pilot’s Guide for the Tecnam P2006T 81
AUDIO PANEL AND CNS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
1 NAV VOL/ID Knob – Controls NAV audio volume level. Press to turn the Morse code identifier audio on
and off. Volume level is shown in the NAV frequency field as a percentage.
2 NAV Frequency Transfer Key – Transfers the standby and active NAV frequencies.
3 NAV Knob – Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for kHz).
Press to move the tuning box (light blue box) and Frequency Transfer Arrow between NAV1 and NAV2.
4 NAV Frequency Box – Displays NAV standby and active frequency fields, volume, and station ID. The
frequency of the NAV radio selected for navigation is displayed in green.
5 COM Frequency Box – Displays COM standby and active frequency fields and volume. The selected COM
transceiver frequency is displayed in green.
6 COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob for
kHz). Press to move the tuning box (light blue box) and Frequency Transfer Arrow between COM1 and
COM2.
7 COM Frequency Transfer Key – Transfers the standby and active COM frequencies. Press and hold this key
for two seconds to tune the emergency frequency (121.500 MHz) automatically into the active frequency
field.
8 COM VOL/SQ Knob – Controls COM audio volume level. Press to turn the COM automatic squelch on
and off. Volume level is shown in the COM frequency field as a percentage.
9 Nearest Airports Window – Display by pressing NRST Softkey.
10 ENT Key – Validates or confirms an Auto-tune selection.
11 FMS Knob – Flight Management System Knob, used to enter transponder codes and Auto-tune entries
when NRST Window is present. Press the FMS Knob to turn the selection cursor on and off. The large
knob moves the cursor in the window. The small knob selects individual characters for the highlighted
cursor location.
12 Transponder Data Box – Indicates the selected transponder code, operating mode, reply, and ident status
for the applicable transponder.