Fluke Networks CertiFiber Pro Users Manual - Manual (Page 179)

Chapter 7: How to Certify Fiber Cabling
CertiFiber Pro Connectors, Keys, and LEDs
157
The LED below the output port is red when the port transmits
1310 nm and green for 1550 nm.
 Input port with removable connector adapter and dust cap.
This port receives optical signals for loss, length, and power
measurements.
 Multimode output port with removable connector adapter and
dust cap. This port transmits optical signals for loss and length
measurements.
The LED below the output port is red when the port transmits
850 nm and green for 1300 nm.
 Universal fiber connector (with dust cap) for the visual fault
locator. The connector accepts 2.5 mm ferrules. The LED below
the connector shows the locator’s mode.
 Button to manually control the output ports (  and  ) and the
visual fault locator (  ).
 Micro-AB USB port: This USB port lets you connect the tester to a
PC so you can upload test results to the PC and install software
updates in the tester.
 Type A USB port: This USB host port lets you save test results on a
USB flash drive or connect a video probe to the tester.
 Headset jack
  : Starts a test. To start a test, you can also tap TEST on the
display.
  : Power key
  : Press  to go to the home screen.
 Connector for the AC adapter. The LED is red when the battery
charges, and green when the battery is fully charged. The LED is
yellow if the battery will not charge. See “Charge the Battery”
on page 13.
 RJ45 connector: For functions available in future software
releases.