Fluke Networks CertiFiber Pro Users Manual User Manual
Page 43
Chapter 1: Get Acquainted
The HOME Screen
21
The number of results from tests on twisted pair cable that
have measurements within the range of accuracy uncertainty for
the tester. See “PASS*/FAIL* Results” on page 79.
The test setup panel shows the settings the tester will use when
you tap TEST or press .
To change these settings, tap the panel, select the test on the
CHANGE TEST screen, tap EDIT, select different settings on the
TEST SETUP screen, then tap SAVE.
Note
You can set up tests for any module that the
tester can use, even when no module is attached.
For copper test setups, icons show the status of the Store Plot
Data and AC Wire Map settings. See Table 2 on page 72.
Next ID: The Next ID panel shows the ID that the tester gives to
the next test results you save.
Tap Next ID to do these tasks:
Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
Turn Auto Save on or off.
Select End 1 or End 2 for OTDR and FiberInspector tests
and loss/length tests in Far End Source mode.
Enter a name for End 1 and End 2.
Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names.
TOOLS: The TOOLS menu lets you set up the compensation
function for the launch/tail cords, use tools such as the real-time
trace and the FiberInspector test, see the status of the tester, and
set user preferences such as the language and the display
brightness.