Spicer Driveline Components Catalog - End Yokes - Manual (Page 14)

J300P-4
END YOKES with SPLINED HOLES
R Q S End Yoke Assy. Slinger/Plug Spicer
Major Ground Length Centerline C'Bore Style (includes slinger/plug) Part Part
Diameter Hub Dia. Thru Hole to End Depth Order When Listed Number Number
12
Important: See Safety Information in General Information Section (J300P-GI)
• Part is discontinued  Part is available until supply is exhausted © Not sold separately
BS/CV/HR/UB Style
SPL250 SERIES (Continued) E-6.412 IN. D-2.362 IN. USE KIT SPL250X
USE BEARING RETAINED NO. 250-70-18X
2.544-49 Involute Spline
2.544 3.819 2.672 6.200 .240 HR 5008445 5008437 250-4-1031-1©
5008445 was replaced by 250-4-08445-1X; 131446K = 5008445 yoke assy & nut# 131095; Spicer axles only
2.544 3.819 2.672 6.200 .240 HR 250-4-08445-1X 5008437 250-4-1031-1©
131446K = 5008445 yoke assy & nut# 131095; Spicer axles only
2.544 3.819 2.672 6.200 .240 HR 131446K 5008437 5008445
5008445 was replaced by 250-4-08445-1X; Attach nut #131095 on Spicer Axle only
2.635-20 Involute Spline
2.635 3.750 2.750 6.270 — HR 250-4-521-1X 231745 250-4-511-1•
Hub machined for speedometer gear; Hub Dia. 3.000 if used on Spicer 1241 Aux. Trans.
2.750-10 Spline
2.750 — 3.000 6.310 — HR — — 250-4-251-1•
2.750 3.500 3.000 6.312 — HR 250-4-761-1X 230674 250-4-751-1•
2.750 3.750 3.000 6.297 — HR 250-4-241-1X 231616 250-4-231-1•
2.750 3.750 3.000 6.300 — HR 250-4-221-1X 230902 250-4-211-1©
2.750 4.000 2.935 6.370 — HR — — 250-4-551-1
Hub machined for speedometer gear
2.794-54 Involute Spline
2.794 — 2.750 5.703 — HR — — 250-4-271-1
Hub diameter not ground
2.794 3.750 2.770 6.330 — HR — — 250-4-901-1
2.795-55 Involute Spline
2.795 4.725 2.047 5.413 .150 HR — — 250-4-501-1•
2.922-22 Involute Spline
2.922 4.067 2.645 6.030 .400 HR — — 250-4-911-1
3.124-48 Involute Spline
3.124 4.250 1.955 5.079 — HR — — 5005681©
OEM only