VEGA VEGAFLEX 66 (-110…+400°C) 4 … 20 mA_HART - Manual (Page 6)

D uring the entire duration of use, the user is obliged to
determine the compliance of the required occupational safety
measures with the current valid rules and regulations and also
take note of new regulations.
2.5 Safety approval markings and safety tips
T he safety approval markings and safety tips on the device
must be observed.
2.6 CE conformity
T he protection goals of the EMC Directive 2004/108/EC (EMC)
and the Low Voltage Directive 2006/95/EC (LVD) are fulfilled.
C onformity has been judged according to the following
standards:
EMC: EN 61326-1: 2006
(
electrical instruments for control technology and laboratory
use - EMC requirements)
l
E mission: Class B
l
S
usceptibility: Industrial areas
LVD: EN 61010-1: 2001
(
safety regulations for electrical measurement, control and
laboratory instruments - part 1: General requirements)
2.7 Fulfilling of NAMUR recommendations
W ith respect to interference resistance and emitted interfer-
ence, the NAMUR recommendation NE 21 is fulfilled.
W
ith respect to compatibility, the NAMUR recommendation
NE 53 is fulfilled. This applies also to the corresponding
indicating and adjustment components. VEGA instruments are
generally upward and downward compatible.
l
S ensor software for DTM VEGAFLEX 66 HART, PA or FF
l
DTM VEGAFLEX 66 for adjustment software PACTware
l
I ndicating and adjustment module for sensor software
T he parameter adjustment of the basic sensor functions is
independent of the software version. The range of available
functions depends on the respective software version of the
individual components.
T
he software version of VEGAFLEX 66 can be determined as
follows:
6 VEGAFLEX 66 • 4 … 20 mA/HART
2 F or your safety
32762
-EN
-080716