VEGA VEGASOURCE 35 Emitter loading and exchange User Manual
Page 10
l
Fit the padlock (1) and lock
l
Let the fixing pin (3) snap in
l
Tighten locking screw (2)
l
Screw in capstan screw (6) and secure together with the retaining
pin (5) with new seal
l
Attach safety catch (4)
l
Remove existing type labels (when exchanging the emitter)
l
Unpack the type label set and letter it respectively. You can find
further information in chapter "Safety instructions - Labelling"
2
1
3
Fig. 8: Fasten type label
1
Adhesive label "Radioactive"
2
Type label - Source
3
Type label - source container (already on the source container)
l
Letter the type label (55 x 45 mm) and fasten with four grooved
pins to the source holder
l
Attach the adhesive label "Radioactive" to the source container (if
not already present)
l
Insertion or exchange of the source is hence finished
Attach or replace the
type labels
10
Emitter loading and exchange • VEGASOURCE 31 35
2 Loading or emitter exchange
39155
-EN
-110210