VEGA VEGASOURCE 35 Emitter loading and exchange - Manual (Page 20)

l
Check if the source container is in position OFF. The arrow mark
(A) of the source holder (6) must be above the OFF mark of the
adapter washer (7)
l
Attach the complete drive unit from above - when attaching make
sure that the two straps of the adapter disc and the drive unit are
on top of the other (B)
l
Fasten drive unit with the three fixing screws - drive unit (2)
l
Fit the padlock (3) and lock, to protect the source capsule against
unauthorized access
l
Attach new seal (4)
l
Connect the pneumatic and feeding lines - the pneumatic lines
must be unpressurized. See operating instructions of the source
container
l Remove padlock - Switching function (1)
l
Insertion or exchange of the source is hence finished
20 Emitter loading and exchange • VEGASOURCE 31 35
2 Loading or emitter exchange
39155
-EN
-110210