VEGA VEGASOURCE 35 Emitter loading and exchange - Manual (Page 15)

l
Allen key size 2.5 (optional)
l
Flat-headed screwdriver size 1.5 x 10
l
Flat-headed screwdriver size 4 mm
l
Side cutters
l
Gripper tool or manipulator for source capsule
l
Possibly extension rod M6
l
Remove padlock (1)
l
Loosen locking screw (2) with a flat head screwdriver 1.5 x 10
l
Remove the seal of the capstan screw (3) with the side cutting
pliers and pull out the seal wire
l
Unscrew the capstan screw (3) until the fixing strap (4) can be
folded up
l
Fold up the fixing strap (4)
Fig. 13: VEGASOURCE - version D in extraction position
l
If necessary, screw an extension rod (9) with thread M6 into the
thread of the source holder (5). With this extension you can
increase the distance to the emitter
l
Unscrew source holder (5) with spanner (size 13) and pull it out of
the source container
l
Only when exchanging the emitted: Insert the blade of a
screwdriver (4 mm) into the slot (6) on the source holder (5) and
press out the source capsule (7) or unscrew the source capsule
with a screwdriver (2 mm). Let the source capsule (7) fall into a
shielded vessel
Remove source holder
Insert or exchange emit-
ter
Emitter loading and exchange • VEGASOURCE 31 35 15
2 Loading or emitter exchange
39155
-
EN
-110210