VEGA VEGASOURCE 35 Emitter loading and exchange - Manual (Page 9)

l
Side cutters
l
Gripper tool or manipulator for source capsule
l
Possibly extension rod M8
l
Remove padlock (1)
l
Loosen locking screw (2) with a flat head screwdriver 1.5 x 10
l
Pull out fixing pin (3)
l
Remove safety catch (4)
l
Remove the seal between holding pin (5) and capstan screw (6)
with side cutting pliers and pull out the seal wire
l
Unscrew the capstan screw (5) with a flat headed screwdriver,
size 1.5 x 10
l
Insert the holding pin (5) and move with the stirrup over the pin
l
Bring the stirrup to the extraction position
Fig. 7: VEGASOURCE - version B in extraction position
l
If necessary, screw an extension rod (11) with thread M8 into the
socket of the source holder (10). With this extension you can
increase the distance to the emitter
l
Pull out the source holder (10)
l
If it is present, remove the safety bolt (7), Allen key size 2.5
l
Swivel the cover (8) in front on the thin cylinder of the source
holder (10) to the side. To do this, lift the cover (8) slightly with a
small slotted screwdriver
l
Only when exchanging the emitter: Allow the source capsule (9) to
fall out downwards into a shielded vessel
l
Insert new source capsule (9) and close cover (8). For insertion
use a suitable gripping device or a manipulator
l
Screw in the safety bolt (7) (optional)
l
Completely insert the source holder (10) into the source container
and turn it until the holding pin (5) pops out
l
If necessary, remove extension rod (11)
l
Continue turning the source holder (10) up to position OFF
Remove source holder
Insert or exchange emit-
ter
Insert source holder
Emitter loading and exchange • VEGASOURCE 31 35 9
2 Loading or emitter exchange
39155
-
EN
-110210