Printronix Online Data Validator - Manual (Page 111)

111
A
Adjusting the scanning beam, 35, 41
Auto detect bar codes, 59, 89
Auto Report, 55
Auto Report Time, 55
Average BWD, 58
B
Bad bar codes, 89
Bar Code Demo Page, 44
Bar code fails / Job has errors, 96
Bar code failure, 89
Bar code grading, 66
Bar Code Improper / Data Format, 96
Bar code quiet / zone too small, 97
Bar codes supported, 13
Bar width deviation, 58, 64
Beam adjustment, 35
Beam Shift, 83
Beam shifting, 41
Beam Width, 82
BWD, 58
C
Calibration / warning, 97
Calibration, setting, 42
Checksum Failure, 97
Clear Data, 56
Clear validator data, 56
Configuring, 53
Contact information, 107
Contrast too low / Check media, 98
Customer Support Center, 107
D
Decodeability, 64
Defects, 65
Demo Page, 44
Disabling validator, 53
E
EC Min, 69
Enabling the validator, 34
Enabling validator, 54
Error action, 90
Grade&Report, 94
Overstrike Mode, 92
Rescan Form, 94
Rescan&Retry, 95
Rescan&Stop, 95
Retry Form, 93
Stop Mode, 92
Stop & Retry, 93
Error messages, 96
Bar code fails / Job has errors, 96
Bar Code Improper / Data Format, 96
Bar code quiet / zone too small, 97
Calibration / warning, 97
Checksum Failure, 97
Index