Printronix Online Data Validator - Manual (Page 31)

Attach the Power/Data Cable
31
Attach the Power/Data Cable
Figure 15. Attaching the Power/Data Cable
1. Plug the DB15 connector end of the power/data cable into the
validator.
2. Route the power/data cable along the inside of the bracket, as
shown in Figure 15.
3. Route a tie wrap from the inside of the bracket through the first
upper slot as shown in Figure 15, keeping the power/data cable
underneath the tie wrap.
183342a
Tie Wrap (2)
Power/Data Cable
DB15 Connector
Validator
Bracket
First Upper
Slot