Printronix Online Data Validator - Manual (Page 37)

Cut Media Handling Mode
37
Figure 19. Aligning the Scanning Beam: Peel-Off Media Handling Mode Only
Cut Media Handling Mode
If your printer has a cutter installed and is configured for Cut Media
Handling Mode, align the beam at the notches at each side of the
opening on the upper enclosure, as shown in Detail A of Figure 20.
IMPORTANT The beam must make direct contact with the media, not the
inside metal part of the cutter. See Figure 22 for instructions
on how to adjust the vertical position of the beam.
Figure 20. Aligning the Scanning Beam: Cutter Installed
183464a
0.20 inches
(5.07 mm)
183465a 183465a
A
See Figure 21,
Detail A on
page 38.