TC Electronic DB8 MKII - Manual (Page 44)

44
smpTe
Event Settings
Operation
• To access Event settings, press Modify in the Edit page.
• Set up all parameters for the Event you are about to
Modify or Insert.
• Press OK to confirm.
Time
The time where the Event being Modified or Inserted
is taking place.
Step/Adjust
Range: Frame, 1 Second, 10 Seconds, 1 min.,
10 min. or 1 hour.
Use the Step parameter to select Adjust range and the
Adjust parameter to increase/decrease the time.
Device
This parameter selects which Mainframe connected to the
LAN you are working on. Device numbers 1-8, corresponds
to the Device position at the Select page.
Preset Type
Selects whether the preset Event you are working on is a
Scene, Routing, Engine or a System preset.
Bank
Select the bank related to the preset you are about to
setup/recall via SMPTE.
Preset
Select the preset from the selected bank.
File
Current List
Keep
Press to save the Event List locally on the Icon. It is possible
to save one Event List on the Icon. Additional cue-lists can
be stored and recalled on a PCMCIA card..
The Keep key will turn red as soon as any editing of the list
has taken place, indicating that you must press to save the
list.
This key corresponds/is the same, as the Keep key located
on the Edit page. (see previous page)
Revert
This “Undo” function allows you to revert the to the last
saved SMPTE Event list. This is the List that is stored
locally on the TC Icon.
Clear
Press Clear to delete the entire SMPTE Event list present
in the TC Icon.
File Storage
Event lists can easily be organized and saved to a
PCMCIA card in the Mainframe. Mainframe selection is
done in the Auto Edit page.
PC
Press to get a list of all SMPTE Event lists stored on the
connected computers hard drive.
Card
Press to get a list of all SMPTE Event lists stored on a
PCMCIA card.
New
Press New to create and name a new Event list.
Save
Press to save the current Event list.
Load
Press to load Event list.
Delete
Press to delete selected Event preset from the
Event Preset list.