Dsp and i/o expansion cards, I/o cards – TC Electronic DB8 MKII User Manual

Page 9

Advertising

HW & installation

I/O Cards

I/O cards MUST be mounted in slots A, B and C

consecutively starting in slot A. Dip-switches must be

correctly set on the I/O cards.

For DSP cards all jumpers must be set to off (up position)

For I/O cards jumper 2 must be set to on (down-position)

To install a DSP or I/O expansion card in your Frame.
1 Switch OFF the unit and disconnect the mains power

cord.

2. Remove the DUM-1 option plate(s) or module by

loosening the 2 screws.

3. Insert the card gently and mount the two screws.

Static Electricity
As all computer hardware can be sensitive to static

electricity, certain precautions must be taken to protect it

from damage during storage and handling.

Storage
Non-mounted modules should always be stored in

anti-static shielded bags.

General Handling
When inserting or removing any modules, avoid touching

the circuit board by handling only the rear panel of the

module. To minimize the static potentials that can cause

damage to the electronic circuits, you should observe

precautionary grounding techniques such as touching

a grounded DB4/DB8 Mainframe immediately before

inserting modules.

Removing Modules
Before removing any card from your Mainframe, unplug

the mains power cable. Unplug all other connections from

the module before unscrewing the two screws securing the

module in the Mainframe. When removing a module from a

Mainframe, the card should be mounted directly in another

Mainframe or placed in an anti-static shielded bag.

Mounting Modules
Before mounting modules in your DB8/DB4, unplug the

mains power cable. Remove the dummy-panel or original

module from the slot where you want to install the module.

The module should then be removed from the shielded bag

and mounted directly in the Mainframe by handling the rear

panel of the module only. Avoid touching any components

on the PCB-Board.

Caution!
The servicing instructions are for

use by qualified personnel only. To

reduce the risk of electric shock do

not perform any servicing other than

that in the operation instructions

unless you are qualified to do so.

DUAL POWER INLETS

LAN

ETHERNET

OFF

GROUNDLIFT

100-240V

50-60Hz 60W

SERIAL NO.

CAUTION

SHOCK HAZARD DO NOT OPEN

AVIS: RISIQUE DE CHOC

ELECTRIQUE NE PAS OUVRIR

TYPE:M6000F20

MADE IN DENMARK

THIS CLASS B DIGITAL DEVICE MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE-CAUSING EQUIPMENT REGULATIONS

AND COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION SUBJECT TO CONDITIONS STATED IN THE MANUAL.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.

MIDI IN

MIDI THRU

MIDI OUT

REMOTE

SMPTE

PEDAL

IO-6000 SDI HD

AUDIO EMBEDDER / DE-EMBEDDER

individually buffered

SDI inputs

IEEE-1394

bypass relay

SDI outputs

DSP6000 SDI