TC Electronic G-System - Manual (Page 14)

Other Important Issues
The following is a list of other important issues you
should take care of when setting up your system. Please
refer to the relevant sections of this manual. Use the
Table of Contents (page 3) for directions.
Read the Section “Setup Examples”
The “Setup Examples” sections gives a good overview of
how the G-System can be connected to the rest of your
gear.
Use correct cables for …
-
Loops 1 to 4
- the Insert loop
- Expression pedals
Calibrate your expression pedals
Expression pedals must be calibrated for best
performance.
Make good use of the Boost feature
You can set a boost level in each preset and activate it
using the BOOST switch.
Use the Locking functions to protect settings
- Lock the Insert loops if you have a pre-amp
connected in that loop and wish to use the pre-amp in
all presets.
- Lock the Boost level to have the exact same boost
level in all presets.
- Lock the EQ section if you use the same EQ in all
presets (i.e., as a “master EQ”).
- Lock Relays to keep the same relay settings
regardless of how the relays are set in presets.
- Lock the Routing type if you only need to use one
routing.
All Locking functions are located in the Utility menu.
Get the most out of your amp(s)
using switch options
You can switch channels on your amp using the G-
System’s four relays. Of course, these settings can also
be stored as parts of presets.
Input Select
You must decide whether you want to use the Input on
the front or on the rear of the GFX01. This is configured
using the Input Select parameter in the Global (Glb)
Levels menu. Press EDIT->MENU->turn PAGE.
QUICK SETUP GUIDE
12