TC Electronic G-System - Manual (Page 28)

TYPICAL SETUPS
26
Three-way: Split to Multiple Amps
Drive Pedals
Send R
etur
n
Send R
etur
n
Send R
etur
n
Send R
etur
n
Loop 1 Loop 2 Loop 3 Loop 4
TAP TEMPO
EDIT PARAMETER B EDIT PARAMETER C SELECT PAGE EDIT PARAMETER A GAIN ADJUST
HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE
PRESETABLE BOOST LEVEL
LEVEL SET
EDIT A EDIT B EDIT C
GLOBAL TEMPO
FORMANT | WAH | EFFECT FILTERS COMPRESSOR ALGORITHM
MODE MENU WHAMMY | PITCH ALGORITHM CHORUS | FLANGER | TREMOLO
| RETURN ENTER
HI-CLASS | TAPE ECHO | DYNAMIC REVERB ALGORITHM
INPUT DAMP
EDITED COM FLT PIT DLY REV E1: E2: E3: E4: E5: INTEGRATED EFFECTS +MANAGEMENT
FILTER LOOP LOOP LOOP EDIT 1 2 3 COMP
UP
DOWN
MOD PITCH DELAY REVERB BOOST
ENCODER ENCODER ENCODER ENCODER ENCODER ENCODER
Expression
P
edal
Expression/V
olume
P
edal
Combo amp
INPUT OR EFFETCTS RETURN
Out Insert
Guitar Input
Combo amp
INPUT OR EFFETCTS RETURN
Combo amp
INPUT OR EFFETCTS RETURN
Send R
etur
n
CENTER
RIGHT
LEFT
PUSH
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
In this particular setup, the center amp is receiving the
dry signal only – i.e, with no effects apart from those
added via the active pedals in Loops 1 to 4.
The left and right amplifiers receive only the effects.
On all G-System presets, “Mix” must be set to 100%.
In this particular setup, the mix of the effects is set solely
using each effect’s Out level parameter.