TC Electronic G-System - Manual (Page 68)

Octaver
The Octaver gives you an additional voice with a fixed
pitch distance of either one or two octaves above or
below the Input note.
Dir - Direction
Range: Up or Down
This parameter sets whether the added voice should be
above or below the input note.
Range
Range: 1 or 2 octaves
This parameter sets the interval of the added voice. Use
the Direct parameter to determine whether the added
voice should be above or below the Input signal.
Mix
Range: 0 to 100%
This parameter sets the relationship between the dry
signal and the level of the effect in this Effect Block.
OutLev – Outlevel
Range: -100 to 0dB
This parameter sets the overall Output level of this effect.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
Whammy
The Whammy effect allows you to control the pitch of an
added voice with an external Expression pedal.
For Factory presets including the Whammy effect, the
Expression pedal connected to the Expression Pedal
Input automatically controls the Pitch parameter, i.e. it
acts as a Whammy Pedal.
Pitch
Range: 0 to 100%
This parameter sets the amount of pitch shift relative to
the Range setting. A connected pedal adjusts this
parameter.
Dir – Direction
Range: Up – Down
This parameter determines whether the attached
Expression pedal should increase or decrease pitch
when moved in either direction.
Per default, pitch is up when the pedal is at “toe down
position”, i.e. this is the “Up” position.
Range
Range: 1-Oct/2-Oct
This parameter sets the range of the pitching effect.
Select 2-Oct for an extreme and 1-Oct for the more
commonly used, subtle Whammy effect.
OutLev – Out Level
Range: -100 to 0dB
This parameter sets the overall Output level of this effect.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
EFFECTS – PITCH
66