TC Electronic G-System - Manual (Page 69)

Detune
The Detune effect is – to some extent – similar to a
Chorus: The source signal is split and a specified amount
of the signal is detuned by an adjustable amount of
Cents (100 Cent = 1 semitone). The main difference
between the Detune effect and the Chorus effect is that
the Detune amount does not change: the modulating
pitch is specified as an offset to the original pitch.
The Detune effect comprises two voices. If you think your
sound is simply too direct and clean, try a setting with
only a few Cent off on both voices – e.g. +2 Cent on
Voice 1 and -3 Cent on Voice 2.
Voice1
Range: -100 to 100
This parameter determines the pitch offset for the first
Voice in the Detune block.
Voice2
Range: -100 to 100
This parameter determines the pitch offset for the second
Voice in the Detune block.
Delay1
Range: 0 to 350ms
This parameter specifies the Delay for the first Voice.
Delay2
Range: 0 to 350ms
This parameter specifies the Delay for the second Voice.
Mix
Range: 0 to 100%
This parameter sets the relationship between the dry
signal and the level of the effect in this Effect Block.
OutLev – Out Level
Range: -100 to 0dB
This parameter sets the overall Output level of this effect.
Enable
Range: Off/On
The effect’s status. All settings are stored as part of the
preset even if this particular effect is disabled.
EFFECTS – PITCH
67