TC Electronic G-System - Manual (Page 29)

Dual amp
From Software version 1.05 it is possible, on each preset
to decide how much signal should be sent on left and
right output. This is setup in the Preset Routing menu
located at: EDIT->MENU->Prst Routing
With this option you can e.g:
• Send all clean sounds to the amp connected to left
output.
• Send all drive sounds to the amp connected to right
output.
• Use both connected amps on some presets and even
have control of the output level sent to each amp.
In the setup illustrated below the pre-amp section of one
amp is connected to Loop 4 and the pre-amp of the other
amp to the Insert-loop.
This means that you are able to select which pre-amp-
section (or both) you would like to use for each preset.
Most often you would NOT use both pre-amps at the
same time.
A similar common application could be using the G-
System with a just few drive pedals and two different
amps of your choice. E.g. one for drive sounds and one
for clean sounds. On Each preset you decide which amp
to send the signal to.
Compared to the illustration below that would mean no
cables to the amps Send/Return connections.
TYPICAL SETUPS
27
For advice on how to connect the drive and
expression pedals, please refer to the descriptions
on the previous pages.
PUSH
Combo amp
Send Input Return
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
BOOST ON
vintage pre-drive
Drive Pedals
TAP TEMPO
EDIT PARAMETER B EDIT PARAMETER C SELECT PAGE EDIT PARAMETER A GAIN ADJUST
HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE HOLD TO STORE
PRESETABLE BOOST LEVEL
LEVEL SET
EDIT A EDIT B EDIT C
GLOBAL TEMPO
FORMANT | WAH | EFFECT FILTERS COMPRESSOR ALGORITHM
MODE MENU WHAMMY | PITCH ALGORITHM CHORUS | FLANGER | TREMOLO
| RETURN ENTER
HI-CLASS | TAPE ECHO | DYNAMIC REVERB ALGORITHM
INPUT DAMP
EDITED COM FLT PIT DLY REV E1: E2: E3: E4: E5: INTEGRATED EFFECTS +MANAGEMENT
FILTER LOOP LOOP LOOP EDIT 1 2 3 COMP
UP
DOWN
MOD PITCH DELAY REVERB BOOST
ENCODER ENCODER ENCODER ENCODER ENCODER ENCODER
Send R
etur
n
Send R
etur
n
Send R
etur
n
Loop 1
Expression
P
edal
Loop 2 Loop 3 Loop 4
Expression/V
olume
P edal
Out Insert
Guitar Input Send R
etur
n
Send Input
HEAD
Return
CAB
Right Le
ft
Send R
etur
n