R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 5 - Manual (Page 36)

LM05 SERIES II I&M MANUAL/EN/11.30.2010
36/89
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
7.6 Chain Container
Figure 15. Chain Container Installation
m
CAUTION: Chain container must be installed for effective operation of travel limit switch.
7.6.1 Removing Chain Container (Figure 15)
1. Remove cotter pin (item 5) from end of pin (item 3).
2. Pull pin (item 3) out while supporting chain container (item 2).
3. Remove chain container (item 2).
7.6.2 Installing Chain Container (Figure 15)
1. Insert load chain into chain container (item 2). Position chain container (item 2) onto hoist mounting
bracket (item 1).
2. Align holes and insert pin (item 3) through container (item 2) and hoist mounting bracket (item 1).
3. Place washer (item 4) onto pin (item 3).
4. Insert and secure cotter pin (item 5).