R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 5 - Manual (Page 61)

LM05 SERIES II I&M MANUAL/EN/11.30.2010
61/89
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
8 PREVENTATIVE MAINTENANCE
8.1 Maintenance and Inspection Table
Table 11. Maintenance and Inspection Schedule
INSPECTION CHECK INTERVAL QUALIFIED PERSON
BRAKE OPERATION FOR HOLDING AND RELEASING DAILY OPERATOR
LOAD CHAIN FOR DAMAGE DAILY OPERATOR
SUSPENSION SUPPORT OF P/ B ASSEMBLY DAILY OPERATOR
CLEANLINESS & LUBRICATION OF LOAD CHAIN MONTHLY OPERATOR
UPPER / LOWER LIMIT SWITCHES DAILY OPERATOR
CHECK LOAD CHAIN FOR WEAR – MEASURE AND RECORD EVERY 3 MONTHS QUALIFIED INSPECTOR
CHECK HOOKS FOR WEAR MEASURE AND RECORD EVERY 3 MONTHS QUALIFIED INSPECTOR
CHECK LOAD BLOCK HARDWARE TO VERIFY TIGHTNESS EVERY 3 MONTHS OPERATOR
CHECK TOP HOOK / COUPLING HARDWARE FOR TIGHTNESS EVERY 3 MONTHS OPERATOR
CHECK SLIP CLUTCH & HOIST BRAKE ADJUSTMENT EVERY 3 -6 MONTHS QUALIFIED MECHANIC
CHECK LUBRICATION OF OPEN WHEEL GEARING EVERY 3 -6 MONTHS QUALIFIED MECHANIC
CHECK WIRE TERMINALS TIGHTNESS SEMI-ANNUALLY QUALIFIED MECHANIC
LUBRICATE 2-FALL LOAD BLOCK SPROCKET ANNUALLY OPERATOR
CHECK ALL HARDWARE FOR TIGHTNESS AND CORROSION ANNUALLY QUALIFIED MECHANIC
CLEAN MOTOR COOLING FINS ANNUALLY QUALIFIED MECHANIC
LUBRICATE ALL GEARING ANNUALLY QUALIFIED MECHANIC
INSPECT LOAD BLOCK THRUST BEARING ANNUALLY QUALIFIED MECHANIC
m
CAUTION: INSPECTION AND MAINTENANCE INTERVALS SHOULD BE ADJUSTED BASED
UPON OWNER / USER KNOWLEDGE OF APPLICATION, ENVIRONMENT, AND FREQUENCY
OF USE TO PREVENT DAMAGE TO PEOPLE, EQUIPMENT, AND FACILITIES.