R&M Materials Handling VARIABLE SPEED CONTROLS ControlMaster Plus Service Manual - Manual (Page 25)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
25/83 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
2 PARAMETER ADJUSTMENTS
2.1 The display panel
READY FAULT STOP RUN ALARM
V 4.18.
Motor Speed
2002 rpm
START
STOP
enter selec
t
reset
ready run fault
I/O term Keypad
The display panel is used for:
Displaying the drive identification, electrical values, operating or fault parameters
Altering the parameter settings
Saving and restoring the parameter settings in the memory of the display panel
Meaning of the displays:
RUN
Motor is running, blinks when ramping down.
Direction of motor rotation.
STOP
Motor is not running.
READY
Power is on. In case of a trip, the symbol will not light up.
ALARM
Drive is running outside of certain limit.
FAULT
Fault is on
I/O term
I/O-terminals are the selected control place
Keypad
Keypad is the selected control place
The signalling LED’s
“ready” Power is on.
“run” Motor is running, blinks when ramping down.
“fault” Fault trip
Button description
reset
Reset active faults
select
Switch between two latest displays
enter
Confirmation of selections
Fault history reset
Browse the main menu and the pages of submenus
Edit values
Move in menu
Move cursor
Enter and exit edit mode
START
Start button
Starts motor if the keypad is the active control place